© 2019 NFR Partners Inc. Portland Maine USA

1 September 2019 EditNC 11.5 is available

11.5 can be installed over any 11.X release and is available at no charge to R11 licensees. New option to set English/Metric units defaults New “Auto Determine” option to specify tool change commands “Visualization Plane” added to backplotter – easier to see orientation Improvements to General Analysis Bug fixes

6 August 2019 - New Videos Posted

We just posted part 3 of an EditNC overview video series. Click here to take a look.

25 April 2019 EditNC 11.4.1 update is available

If you have already installed 11.4.0, you can skip this update unless you have problems with the items below. G72 facing cycle corrected for right-to-left facing Minor tool change issue resolved A Word About Viruses We are receiving more and more reports of warnings created by various malware checkers.. We test our code against several virus checkers etc but can’t test them all. Our release 11.2 setup file recently showed zero hits from 64 checkers and the 11.2 editor exe file showed 4 hits out of 66 checkers. Microsoft Windows Defender for Windows R10 has reported possible malware also. We have reported these as false positives to several vendors and without exception have received responses stating that the files were indeed clean. The editor has a "taggant" embedded that identifies us via a third party service as the developers and is signed using both SHA-1 and SHA256 certificates. If your malware detector reports any of our software as infected, please have the vendor analyze the file (most or all provide easy-to-use procedures for doing this) and let us know also as we can follow up. Thank you.

EditNC by NFR Partners Inc

N E WS
© 2018 NFR Partners Inc. Portland Maine USA

1 September 2019 EditNC 11.5 is available

11.5 can be installed over any 11.X release and is available at no charge to R11 licensees. New option to set English/Metric units defaults New “Auto Determine” option to specify tool change commands “Visualization Plane” added to backplotter – easier to see orientation Improvements to General Analysis Bug fixes

6 August 2019 - New Videos Posted

We just posted part 3 of an EditNC overview video series. Click here to take a look.

25 April 2019 EditNC 11.4.1 update is available

If you have already installed 11.4.0, you can skip this update unless you have problems with the items below. G72 facing cycle corrected for right-to-left facing Minor tool change issue resolved A Word About Viruses We are receiving more and more reports of warnings created by various malware checkers.. We test our code against several virus checkers etc but can’t test them all. Our release 11.2 setup file recently showed zero hits from 64 checkers and the 11.2 editor exe file showed 4 hits out of 66 checkers. Microsoft Windows Defender for Windows R10 has reported possible malware also. We have reported these as false positives to several vendors and without exception have received responses stating that the files were indeed clean. The editor has a "taggant" embedded that identifies us via a third party service as the developers and is signed using both SHA-1 and SHA256 certificates. If your malware detector reports any of our software as infected, please have the vendor analyze the file (most or all provide easy-to-use procedures for doing this) and let us know also as we can follow up. Thank you.

EditNC by NFR Partners Inc

N E WS